Elmo EMR-16 Manual de instrucciones Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 126
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
PRECAUTIONS
- Refer all work related to the installation of these products to qualified service
personnel or system installers.
- Do not operate the appliances beyond their specified temperature, humidity, or power
source ratings.
Use the appliance at temperatures within +5 °C - +40 °C (41 °F - 104 °F) and humidity below
80 %.
The input power source for this appliance is 120 V AC 60 Hz.
Performance and lifetime of hard disk drives are easily affected by heat (used at high
temperature) characteristically. It is recommended to use this appliance at temperatures
within +20 °C - +30 °C (68 °F - 86 °F).
- Handle the appliance with care.
Do not strike or shake, as this may damage the appliance.
- Do not strike or give a strong shock to the unit.
It may cause damage or allow water to enter the unit.
- Cooling Fan
Turn off the power when cleaning the unit. Otherwise it may cause injuries.
- Cleaning
Turn off the power when cleaning the unit. Otherwise it may cause injuries.
Do not use strong or abrasive detergents when cleaning the appliance body.
Use a dry cloth to clean the appliance when it is dirty.
When the dirt is hard to remove, use a mild detergent and wipe gently.
- Indication label
Refer to the indication labels placed on the back of the unit as to the indications of equipment
classification and power source, etc.
- Built-in hard disk drives
Hard disk drives are vulnerable to vibration. Handle them with care.
It is possible to damage them if they are moved while their motors are still running. Do not
move them just after turning their power on or off (for around 30 seconds).
When hard disk drive trouble occurs, replace it immediately. Consult your dealer for servicing.
When replacing the hard disk drivers, take notice of the following.
- Place the unit horizontally an a level surface. Do not place the unit in an upright position.
When stacking multiple units, clear a space of more than 5 cm from both sides, the top, the
bottom and the rear of the units.
- Avoid placing receptacles that contain liquids such as water near the unit.
- If liquid spills onto the unit, it may cause fire or an electric shock.
- Do not expose the unit to water or moisture, or try to operate it in wet areas.
- Wait until the dew evaporates in any of the following cases;
- The recorder is placed in an extremely humid place.
- The recorder is placed in a room where a heater has just been turned on.
- The recorder is moved from an air-conditioned room to a humid and high-temperature
room.
- We recommend that you make a note of your settings and save them. This will help when you
are required to change the system configuration, or when unexpected trouble or failure
occurs.
- 3 -
- Distributing, copying, disassembling, reverse compiling, reverse engineering and also
exporting in violation of export laws of the software provided with this product, is expressly
prohibited.
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 125 126

Comentarios a estos manuales

Sin comentarios